What makes the M-Series so efficient? Glad you asked! The M-2000 utilizes 2-rail Class-H circuitry, while the M3000 & M4000 utilize the higher power capacity 3-rail Class-H circuitry. (If you understand this, skip this paragraph and give us a call. We’re always hiring at Mackie.) For the non-engineers among us, 2- and 3-rail Class-H circuitry taps into additional power rails only when needed. This results in much greater efficiency and less destructive heat. So it runs very cool versus other types of power amp designs, especially in real-world applications playing real music. This design not only maximizes power, but also improves long-term reliability. *
power (1kHz@1%THD) M2000 M3000 M4000
8 ohms per channel 400W 600W 800W
4 ohms per channel 650W 1000W 1300W
2 ohms per channel 1000W 1500W 2000W
Bridge Mono mode
8 ohms 1300W 2000W 2600W
4 ohms 2000W 3000W 4000W
Fast Recovery Circuitry
Borrowing from technology found only in high-speed test equipment, the M-Series amplifiers employ Fast Recovery circuitry with Baker Clamps. The Baker Clamps prevent both the output stage and final Class-A voltage amp stage from saturating—a phenomenon known as “sticktion,” where the amplifier delays its recovery past the original input clipping point. When recovery finally does take place, it can be abrupt, and generate a massive amount of higher-order harmonic distortion…. which sounds like, well, crap. Other amp manufacturers forgo the Baker Clamp since its effects are only noticeable when you are clipping your amp. But at Mackie, we know that most folks run their amps at unseemly clipping levels, so we figured it was worth it.
Fast But Remarkably Un-Furious Transients
Before we tell you about the M-Series exclusive Adaptive Slewing technology, here’s what you need to know about slewing: the faster an amplifier’s rate of slew, the better its transient response, the faster its recovery from clipping, and the less risk of slew-induced harmonic distortion through the entire audio band. A Mackie exclusive, new Adaptive Slewing circuitry allows M-Series amplifiers to pass the fastest transient attacks—like kick and snare drum, or any bass player trying to imitate Marcus Miller—while minimizing Class-H switching distortion. As a result, the M-Series have the lowest distortion of any Class-H amplifier on the market. And no matter how hard and fast you thrash, the M-Series amps are gonna be a couple of steps ahead, making sure the output is clean.
50% More Output Components than Our Competitors
Check out the competition, and you’ll find the M-Series amps typically use 50% more output parts for the same power output levels. The M2000 uses 10 output transistors per channel, the M3000 has 12, and the M4000 sports 16. Sure, this costs us a lot more money to design and manufacture. But in extremely hot environments—like a punk show where one amp is driving a real-world 2Ω load like eight speaker cabinets—having more output transistors is the only way to go. So that’s just how we roll.
M-Series power amps employ twice as many output components as competitive models. This costs us a bit more to design and manufacture, but it’s well worth it for the extra reliability.